Fujitsu ScanSnap S1500M User Manual

Parts and Functions
20
Parts and Functions
This section explains names and functions of the ScanSnap parts.
■ Front
ADF paper chute (cover)
Open to use the ScanSnap.
D Opening the ADF paper chute (cover) turns
on the ScanSnap.
Extension
Pull out when scanning long documents.
Side guide
Adjust to the width of documents to prevent
them from getting skewed.
ADF release catch
Pull this tab to open the
ADF top section.
[Scan] button
Press this button to start scanning. Can be
pressed even when the stacker is closed.
It indicates the status of the ScanSnap as follows:
Blue (lit) : Ready
Blue (flashing) : Scanning
Orange (flashing) : Error
ADF paper chute (cover)
You can load the document here after
opening it.
Stacker
Open to use the stacker.
D Stacks up the ejected documents.
ADF top section
Open to remove jammed documents, replace
the pad assy and the pick roller, or clean the
inside of the ScanSnap.

Fujitsu ScanSnap S1500M Specifications

General

Film scanning	No
Color scanning	Yes
Input color depth	- bit
Maximum scan size	216 x 360 mm
Scanner type	Sheet-fed scanner
Sensor type	CCD
ISO A-series sizes (A0...A9)	A4, A5, A6
ISO B-series sizes (B0...B9)	B5, B6
Maximum ISO A-series paper size	A4
Auto document feeder (ADF) input capacity	50 sheets
Bundled software	Cardiris 3.6, Adobe Acrobat 8 Professional, ABBYY FineReader
Scan media weight	52 - 127 g/m²
Dimensions (WxDxH)	292 x 159 x 158 mm
Power requirements	AC 100V to 240V, 50 / 60 Hz
Dimensions (W x D x H) (imperial)	11.5 x 6.3 x 6.2 \
Minimum storage drive space	2440 MB
Sustainability certificates	ENERGY STAR
Power consumption (standby)	4.5 W
Power consumption (typical)	35 W
Operating temperature (T-T)	5 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Certification	RoHS

Weight and Dimensions

Weight	3000 g