How to Perform a Scan (for Mac OS Users)
268
4. Load a document in the ScanSnap.
For details about how to load documents, refer to "How to Load Documents" (page 32).
5. Press the [Scan] button on the ScanSnap to start a scan.
D The [Scan] button on the ScanSnap flashes in blue throughout the scan.
The [ScanSnap Manager - Image scanning and file saving] window appears.
D The application specified for the selected profile starts up when the scanning is
completed.
z The [Scan] button setting is [Duplex Scan (Double-sided)] in default. Note that you can
switch the [Scan] button setting to [Simplex Scan (Single-sided)] in ScanSnap
Manager.
For more details, refer to "Scanning Only One Side of a Document" (page 386).
z You can also start scanning from the ScanSnap Manager menu.
For more details, refer to "ScanSnap Manager Menu" (page 258).
z Do not connect or disconnect the ScanSnap and other USB devices during scanning.
z Do not close the ADF paper chute (cover) during scanning.
z Do not switch users during scanning.
To Next Page
Loading...
