System expansions and repairs
We recommend printing out the relevant sections of this chapter prior to installation
as the device for installing/removing hardware components needs to be switched off.
The following illustrations may differ from your device, depending on its configuration and features.
If you have received any further documents with your device, you should read these through carefully.
Please note the following instructions before installing/removing system components:
■ The device must be switched off when installing/removing components and it must
not be in power-saving mode.
■ Disconnect the mains plug before opening the device.
■ After unplugging the mains plug, discharge the remaining voltage by pressing the
activation button.
■ Remove all externally connected cables.
■ Take care not to pinch any cables when installing/removing components.
■ Please ensure that the installed components that might heat up intensely during
operation do not exceed the permitted operating temperature.
During a system expansion or a hardware upgrade, it is possible that the BIOS must
be updated. You can find more information in the technical information provided for
your device.
To Next Page
Loading...
