AT Commands Table 60
/N 0 Normal speed-buffered mode.
1 Direct mode (if parallel I/F is selected, same as /NO).
2 MNP reliable mode (MNP -> disconnect)
3 Auto-reliable mode (LAPM -> MNP -> NORMAL -> disconnect).
Same as /N5.
3
4 LAPM-reliable mode (LAPM -> disconnect)
5 Auto-reliable mode (LAPM -> MNP -> NORMAL -> disconnect).
Same as /N3.
/V 0 Disable protocol result code appended to DCE speed.
1 Enable protocol result code appended to DCE speed.
3
2 Same as /V1.
/X 0 Do not pass XON/XOFF flow control characters.
3
1 Pass XON/XOFF flow control characters.
-V90=<n> =0 Disable V.90
=1 Enable V.90 Auto Rate
3
=2 Attempt to connect at 28000 bit/s
=3 Attempt to connect at 29333 bit/s
=4 Attempt to connect at 30666 bit/s
=5 Attempt to connect at 32000 bit/s
=6 Attempt to connect at 33333 bit/s
=7 Attempt to connect at 34666 bit/s
=8 Attempt to connect at 36000 bit/s
=9 Attempt to connect at 37333 bit/s
=10 Attempt to connect at 38666 bit/s
=11 Attempt to connect at 40000 bit/s
=12 Attempt to connect at 41333 bit/s
=13 Attempt to connect at 42666 bit/s
=14 Attempt to connect at 44000 bit/s
=15 Attempt to connect at 45333 bit/s
=16 Attempt to connect at 46666 bit/s
=17 Attempt to connect at 48000 bit/s
=18 Attempt to connect at 49333 bit/s
=19 Attempt to connect at 50666 bit/s
=20 Attempt to connect at 52000 bit/s
Command Specification Default
To Next Page
Loading...
Need help?
General