Furuno FELCOM 250

6. WEB FUNCTIONS
6-23
VPN pass-through screen
Click [VPN pass-through] on the group setting screen to show the VPN pass-through
setting screen. Set the screen according to your system.
Common settings screen
On the menu bar, click [Settings], [Network settings], [WAN], [Common settings] to
show the Common settings setting screen.
Display user list
On the menu bar, click [Settings], [Network settings], [WAN], [User list] to show the
user list screen.
Item Description
IPSec Place a [9] by IPSec pass-through to activate.
PPTP Place a [9] by PPTP pass-through to activate.
Apply button Click to apply changes.
Cancel button Click to ignore changes.
Item Description
Use / unuse Check [9] to use Upnp. Not active in initial setting.
Group Select a group to use from a list box.
Apply button Apply settings.
Cancel button Restore previous settings
Item Description
Group Show group name.
User (IP address) Display IP address of a user registered in a group. If
there is no user registered, the User column is blank.