1. MOUNTING
1-5
How to attach the N-P-8DFB connector
Remove outer sheath and armor by the
dimensions shown left.
Expose inner sheath and shield by the
dimensions shown left.
Cut off insulator and core by 10 mm.
Twist shield end.
Slip on clamp nut, gasket and clamp
as shown left.
Fold back shield over clamp and trim.
Cut aluminum foil at four places,
90° from one another.
Fold back aluminum foil onto shield
and trim.
Expose the insulator by 1 mm.
Expose the core by 5 mm.
Slip the pin onto the conductor. Solder
them together through the hole on the
pin.
Insert the pin into the shell. Screw the
clamp nut into the shell.
(Tighten by turning the clamp nut. Do not
tighten by turning the shell.)
Outer Sheath
Armor
Inner Sheath Shield
Cover with heat-shrink tubing and heat.
Clamp
Nut
Gasket
(reddish
brown)
Clamp
Aluminum Foil
Trim shield here.
Insulator
Trim aluminum tape foil here.
Clamp Nut
Pin
Shell
Solder through
the hole.
30
50
30
10
1
5
To Next Page
Loading...
