3. ADJUSTMENTS
3-19
3.6 Sound Test
Note: It is recommended to keep the default setting. Do not change the setting unless
absolutely necessary.
1. Access to the service menu (Refer to section 3.4).
2. Press the MENU/ESC key to open the main menu.
3. Select [6 Maintenance] then [2 Self Test].
4. Select [5 Sound Test].
5. Press the cursorpad (S or T) to select [Frequency] or [Voltage].
6. Press the cursorpad (W or X) to set the value.
7. Press the MENU/ESC key to close the main menu.
3.7 How to Set Dual Configuration
You can configurate two dual differential GPS navigator systems and an interface unit.
1. Press the MENU/ESC key to open the main menu.
2. Select [7 I/O] then [8 Dual].
3. Select [1 No], [2 Serial (Port2)] or [3 Ethernet].
[No]: Not set dual configuration.
[Serial (Data2)]: Sets dual configuration using data2.
[Ethernet]: Sets dual configuration using Ethernet.
4. Press the MENU/ESC key to close the main menu.
To Next Page
Loading...
