Furuno GP-170 - Ethernet Setup; How to Set the IP Address; SFI Setup

3. ADJUSTMENTS
3-8
3.4 Ethernet Setup
The settings described in this section are done at the service menu which the custom-
er cannot access to. Do as follows to access it.
1. Change the display to the course display (see the Operator’s Manual).
2. Press the cursorpad S, S, T, T, W, X, W, X and then press , , , .
The color of the menus changes from gray to black.
3.4.1 How to Set the IP Address
1. Press the MENU/ESC key to open the main menu.
2. Select [8 System Setting] then [7 Network].
3. Select [2 Ethernet].
4. Enter the IP addresses for your equipment (setting range: 172.16.0.1 to
172.31.255.254), subnet mask and default gateway with the numeric keys.
Note: Be sure the IP address is not the same as other equipment on the network.
5. Move the cursor to [Enter] then press the NU/CU ENT key.
3.4.2 SFI Setup
SFI (System Function ID) is an identification code used by the system.
1. Press the MENU/ESC key to open the main menu.
2. Select [8 System Setting] then [7 Network].
3. Select [4 SFI].