Furuno GP-170 - 3 Adjustments; Checking Operation; Self-Test Display at Equipment Start up

3-1
3. ADJUSTMENTS
3.1 Checking Operation
1. Turn on GP-170.
The following display appears.
Self-test display at equipment start up
2. Confirm “OK” on the self-test display.
Note: The display related to BEACON appears at the bottom of the start-up
screen when DGPS beacon receiver is built in the GP-170.
The following display appears. Your display may look slightly different from the
one shown here depending on the devices connected to your product.
Self test
results
xx
xx
xx