EasyManua.ls Logo

Fuso Multi Use Tester III - User Manual

Fuso Multi Use Tester III
92 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Multi Use Tester III
MUT-III Instruction Manual

Table of Contents

Questions and Answers

  • M
    Mrs. Heather Phelps MDAug 9, 2025
    What to do if Fuso Multi Use Tester III Test Equipment shows Retry? during V.C.I. and ECU communication?
    • K
      Karen SantiagoAug 9, 2025
      If you see a ' Retry?' message during communication between the V.C.I. and ECU, it could be due to several reasons. First, ensure that the IG switch is turned ON. Second, check the communication wire between the V.C.I. and ECU to make sure it is properly connected. If the issue persists, pressing the V.C.I. “Enter” key may allow the diagnosis to proceed.
  • P
    petersonstevenAug 25, 2025
    Why does my Fuso Multi Use Tester III display '< Init. Error > System not Supported'?
    • T
      Taylor CoxAug 25, 2025
      The '< Init. Error > System not Supported' message on your Fuso Test Equipment indicates that the selected systems are not supported for V.C.I. stand-alone diagnosis, or the selected systems do not exist. Use a PC for diagnosis, as the systems may not be supported for V.C.I. stand-alone diagnosis. Also, confirm that the system you selected actually exists.

Fuso Multi Use Tester III Specifications

General IconGeneral
Diode TestYes
Frequency Ranges10Hz to 10MHz
Duty Cycle0.1% to 99.9%
Temperature-40°C to 1000°C
ContinuityYes