EasyManua.ls Logo

Fuso Multi Use Tester III - Operating Procedures for the Drive Recorder Chapter 5 Operating Procedures for the Drive Recorder; Chapter 5 Operating Procedures for the Drive Recorder

Fuso Multi Use Tester III
92 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operating Procedures for the Drive Recorder
36
Chapter 5 Operating Procedures for the Drive Recorder
There are 2 methods used for recording data with the drive recorder:
[1] Method in which data recording is performed using a stand-alone V.C.I..
[2] Method in which data recording is performed using a PC, displaying data.
The sampling rates / times for each of the above methods are shown in the table below.
The most appropriate recording method can be selected to suit the particular application.
[1] Recording Using a Stand-Alone V.C.I. [2] Recording onto a PC
Sampling Rate Fast Slow
Sampling Time Short Long
5-1. Recording with the Drive Recorder
5-1-1. Recording with the Stand-Alone V.C.I. .......................................................................P.37
5-1-2. Recording with the PC................................................................................................P.42
5-1-3. Recording by Using the Previous Settings .................................................................P.48
5-1-4.
Group registration ........................................................................................................P.49
5-2.
Handling the Recorded Data
5-2-1.
Transferring Recorded Data from the V.C.I. to the PC ...................................................P.51
5-2-2.
Regenerating the Recorded Data .................................................................................P.52
5-2-3.
Deleting / Saving the Recorded Data............................................................................P.53
5-2-4.
Loading Recorded Data ...............................................................................................P.54
5-3.
Analyzing Recorded Data
5-3-1.
Regenerating Recorded Data.......................................................................................P.55
5-3-2.
Extracting / Searching the Recorded Data ....................................................................P.58
5-3-3.
Displaying the Correlation Chart / Distribution Chart .....................................................P.59
5-3-4.
Item Order Change Function ........................................................................................P.61
5-3-5.
Data Range Change Function ......................................................................................P.61

Table of Contents