Operating Procedures for Air Suspension Calibration
80
(3) Set the Lower Level
Car height on each of the front / rear can be adjusted.
For the adjustment method, please refer to the service
guide for each vehicle.
--- greatly down --- small down
--- greatly up --- small up
--- Height sensor calibration will be complete, after
the adjustment state is set.
--- Enlarged view of the 4 buttons : go to section (5).
--- The operate mode display : go to section (4).
For ensuring safety, the declining operation is stopped
automatically by the consecutive operation in a given time.
(It stops after 3 Seconds for Front, 10 Seconds for Rear.)
Press the button again if you continue declining operation.
(4) Select the operate mode
--- Setting
--- Return to the previous screen
(5) The button display can be enlarged in order that the
up-and-down setting of car height is performed easier
without looking at a screen.
--- Front / Rear change
--- Return to the previous screen
--- The operate mode display: go to section (4).
This screen is for operating up-and-down setting of car
height, so the adjustment state cannot be fixed here.
Return to the previous screen by the button, and fix
the adjustment state by the button.
To Next Page
Loading...