FUTABA 32MZ-WC - Home Screen

197
＜
Model Menu (Helicopter)
＞
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
+(/,&237(5
HomeScreen
HomeScreen
●SWS.Rate
●PIT.Rate
●SWS.Ring
●FLT.Styl
●Cnt.AuthAI
●Cnt.AuthEL
●EXPO
●HeadHld A
●HeadHld E
●StpTune A
●StpTune E
●HeadResp
●BaseGain AI EL
●CYC.Rt
●GOV.Gain
●L Lmt.H rpm
●L Lmt.L rpm
●BaseGain AI EL
●CYC.Rt
●GOV.Gain
●L Lmt.H rpm
●L Lmt.L rpm
Ｃond1 (Condition 1)
Switch DG1
●SWS.Rate
●PIT.Rate
●SWS.Ring
●FLT.Styl
●Cnt.AuthAI
●Cnt.AuthEL
●EXPO
●HeadHld A
●HeadHld E
●StpTune A
●StpTune E
●HeadResp
Ｃond2 (Condition2)
Neutral
Switch Channel Rate
WideNarrow
-100% 100%-35% 35%0%
*Indicates when the setup style is "3D".
Cond1 Cond2
Switch Channel Rate
Neutral
Cond1
Cond3
Cond5Cond4Cond2
-100% 100%-25%-75% 75%25%0%
-100%
100%
0%
Swash plate type
Displaystheswashplatetypesetin
"SWH.BASIC"menu.
Home Screen Display
On the home screen, basic information such as swash type,
gyro operation mode, sensitivity and governor ON / OFF,
engine operating time etc, are displayed.
Forfunctionsthatcansetconditionsin
thismanual,mark
Cond
iswritten.
Condition number
Withswitchoperationfromthetransmitter,severalparameterscanbeswitchedby
settingupto5typesofdata.Ifyousettheconditionswitchtothechannelhaving
theAFRfunctionofthetransmitterandsetthepointforeachflightconditionwith
theAFRpointcurve,itcanalsobelinkedwiththeflightconditionswitch.
•WheneithertheDG1orDG2switchisselected,thefollowingoptionsareavailable.
FunctionMenuofyourtransmitter(DG1).AssigningDG1toaswitchorflightmodeallowsthe
useoftwoseparatevaluesfortheconditionselectableparameters.
•Ifyousetaconditionswitchchannel,usingtheAFRfunctiononthatchannelsetaflatpoint
curveforeachflightcondition.Thenyoucanutilizeall5flightsconditions.
SetthepointcurvewithAFRforeachflightconditionofthetransmitter.
Governor ON / OFF
IndicatestheON/OFFswitchstatusofthe
governorfunction.When"ON"isdisplayed,
thegovernorfunctionisactivated.
Gyro operation mode /
Gyro gain
Displays"AVCS"or"Normal"operation
modeandgyrogainofaileron(roll),
elevator(pitch)andrudder(yaw)axis.
Roll and Elevator rate maximum display
Thisscreendisplaysthemaximumrollrateandmaximumeleva-
torraterecordedduringflight.Dataisresetwhenthepower
isturnedoff.Ifyouwanttocheckthemaximumrate,leavethe
poweronafterflight.Pressandholdratebuttontoresetthe
display.
Battery voltage
Displaysthevoltageofthe
receiverbatteryconnected
toCGY.
RPM display
ThemaximumRPMoftheengineorrotorheadRPM
memorizedbythegovernorduringoperationisdis
-
played.Dataisresetwhenthepoweristurnedoff.Ifyou
wanttocheckmultipletimesduringtheflight,leavethe
poweronafterflight.PressandholdRPMbuttontoreset
thedisplay.
Engine running time
Displaystherunningtimeoftheengine.Upto9,999
hoursaredisplayed.
Pressandholdtimebuttontoresetthedisplay.The
operationtimeisstoredin memoryevenwhen the
poweristurnedoffuntilitisreset.