NOTE
If you forget to turn off the position lamps when
the engine start/stop button is switched to the
"OFF" position and the car is not locked, the
position lamps will stay on for 15 min and then
go out automatically in order to save the battery
power; when the engine start/stop button is
switched to the "OFF" position and the car is
locked, the position lamps will go out
immediately.
WARNING
• When driving the car at night or on a
road with poor visibility, please do not
only turn on the position lamps,
otherwise, accidents may easily occur.
•
When temporarily parking the car at
night or on a road with poor visibility
with the need of indicating the position
of the car, do not use the position lamps
as the parking lamps but be sure to turn
on the hazard warning lamp due to the
battery
power saving function of the
position lamps.
Low beam
– Turn the light switch to the
position to turn
on the low beam.
High beam
– After turning on the low beam, if you push the
lamplight combination switch forward to the
limit position, the high beam will be turned on
and the corresponding indicator lamp
on
the instrument cluster will come on.
–
If you pull the lamplight combination switch
backward to the original position, the high
beam will be turned off.
High beam flashing
– If you pull the lampli
backward to the limit position, the high beam
will be turned on.
–
If you release the switch, the lamplight
combination switch will automatically return to
its original position and the high beam will be
turned off.
NOTE
• The hig
h beam may cause dazzling to
drivers of oncoming vehicles at close
range, which may easily cause accidents.
Therefore, please use the high beam
reasonably.
•
When all the lamps are turned off, if you
pull and hold the lamplight combination
switch backward,
the high beam will stay
on, and the corresponding indicator lamp
on the instrument cluster will come on.
4. Operation of Systems and Equipment
To Next Page
Loading...
