It should be noted that the zones programmed into a part set suite are programmed by
the engineer and not the user.
To set an area simply enter the required area code (Press YES if a Main Area Code is
used) and exit the area.
To part set an area enter the area code followed by NO and the part set number
required (1, 2 or 3). If Main Area type code is used enter code followed by part set
number.
To unset an area, enter the area code.
Cleaner Code (part set 0) ) Master & Main Codes only
The Cleaner code or part set 0 acts in a different way to the other area codes. To set
the system and remove the cleaner zones Enter code followed by YES, YES 0 This will
set the system or area and remove the cleaner zones.
If a cleaner code is now entered the cleaner zones will also be set.
If a cleaner code is entered when the system is fully set or area set only the cleaner
zones will be unset.
It should be noted that any entry/exit zones that are removed or unset via the cleaner
code or part set 0 will chime when violated. This is to prevent other users straying into
protected areas without warning.
More details of codes and using the system are given in the relevant sections of this
manual, and in the user manuals.
Page 6
PR5892 Rev11 800 Series Eng Ref 15.qxd 16/11/2006 11:20 Page 6
To Next Page
Loading...
