Model 560XL Section III – Operating Procedures
General
190-02313-03 Rev. 8 Textron Aviation Citation 560XL
FAA Approved 3-3
Operating Procedures – General
Some emergency situations require immediate corrective action. These numbered steps are printed in
boxes in the emergency procedures and should be done without the aid of the checklist.
Many of the original AFM procedures are unchanged, however several existing AFM procedures were
modified or removed as part of the G5000 installation. The AFM cross reference sections in this manual
will serve as a guide to locating the correct version of procedures for use with the G5000 installation.
Warning and Test System
The original annunciator panel has been replaced by an integrated CAS in the G5000. The CAS replaces
the warning, caution, and advisory lights of the original annunciator panel. Each warning, caution, and
advisory light that was replaced was directly replaced with an equivalent CAS message that will display
on G5000 CAS.
When using existing AFM procedures, any references to “lights” or “annunciators” apply to CAS
messages of the same text on the G5000 system. AFM references to “annunciator panel” apply to the
CAS display in the G5000.
TAWS or GPWS Flap Override
Several existing AFM procedures include activating the TAWS or GPWS Flap Override button installed on
the instrument panel in the event of a landing with flaps not set to 35°. This button has been removed with
the installation of the G5000 system. The Abnormal Procedures section of this Flight Manual Supplement
includes a procedure for activating the G5000 TAWS Flap Override function.
Any existing AFM procedure that calls for activating TAWS or GPWS Flap Override should now be
accomplished using the G5000 TAWS Flap Override procedure.
To Next Page
Loading...
