Model 560XL Section III – Operating Procedures
Abnormal Procedures
190-02313-03 Rev. 8 Textron Aviation Citation 560XL
FAA Approved 3-55
ADS-B OUT TRANSMISSION FAIL
The G5000 system transmits ADS-B OUT messages using the selected ATC transponder. If the
G5000 system is unable to transmit ADS-B OUT messages, one or both of the following messages
will post as a system message on both GTCs:
“XPDR1 ADS-B FAIL. XPDR1 unable to transmit ADS-B messages.”
AND / OR
“XPDR2 ADS-B FAIL. XPDR2 unable to transmit ADS-B messages.”
1. If only one transponder is affected, select the other transponder. On the GTC, touch the
Transponder Mode button, then touch the Active button and select the other transponder.
Procedure completed
SYNTHETIC VISION DISPLAYS INCONSISTENT WITH PRIMARY
FLIGHT INSTRUMENTATION
1. PFD Settings softkey – PRESS.
2. Attitude Overlays softkey – PRESS.
3. Synthetic Terrain softkey – PRESS.
4. Synthetic Terrain – VERIFY removed from both PFDs. Use G5000 primary displays for
navigation and aircraft control.
Procedure completed
TAWS OR GPWS CAUTION
TERRAIN Annunciator displayed
1. When a TAWS or GPWS CAUTION occurs, take positive corrective action until the alert ceases.
Stop descending or initiate either a climb or a turn, or both, as necessary, based on analysis of all
available instruments and information.
Procedure completed
TAWS OR GPWS FLAP OVERRIDE
During certain flight operations, there may be a requirement by the crew to override the normal
alerting for a landing with flaps not set at 35°. Use the following procedures to override this alerting:
1. GTC: TAWS – TAWS Settings – Flap Override – PRESS
Procedure completed
NOTE
When the Flap Override button is enabled, the annunciation FLAP OVR is displayed on
the PFDs and on the TAWS displays on the MFD and PFDs if enabled.
To Next Page
Loading...
