Garmin G5000 - CHECK RUNWAY Surfacewatch Alert (During Landing); CHECK RUNWAY Surfacewatch Alert (During Takeoff)

Model 560XL Section III – Operating Procedures
Abnormal Procedures
Textron Aviation Citation 560XL 190-02313-03 Rev. 8
3-56 FAA Approved
 CHECK RUNWAY SURFACEWATCH ALERT (DURING TAKEOFF)
CHECK RUNWAY Annunciator displayed and aural “CHECK RUNWAY” message during takeoff
This caution alert is issued when the aircraft is taking off from a runway different than that entered in
the GTC Takeoff Data. The alert will be issued when the thrust is increased above 76% N
1
and the
groundspeed is greater than 30 knots.
1. Aircraft Position/Runway Assignment – CONFIRM.
 IF AIRCRAFT POSITION AND RUNWAY ASSIGNMENT ARE CORRECT:
2. Takeoff – CONTINUE AS DESIRED.
Procedure completed
 IF AIRCRAFT POSITION AND RUNWAY ASSIGNMENT ARE NOT CORRECT OR CANNOT
BE DETERMINED:
2. Takeoff – ABORT.
3. Enter correct origin, runway, and required takeoff distance into the G5000 system:
a. From the GTC Home screen: Perf – Takeoff Data.
Procedure completed
 CHECK RUNWAY SURFACEWATCH ALERT (DURING LANDING)
CHECK RUNWAY Annunciator displayed and aural “CHECK RUNWAY” message during landing
This caution alert is issued when the aircraft is landing on a runway different than that entered in the
GTC Landing Data. The alert will be issued when the aircraft is below 250’ AGL and within one
nautical mile of the airport.
1. Aircraft Position/Runway Assignment – CONFIRM.
 IF AIRCRAFT POSITION AND RUNWAY ASSIGNMENT ARE CORRECT:
2. Approach and Landing – CONTINUE AS DESIRED.
Procedure completed
 IF AIRCRAFT POSITION AND RUNWAY ASSIGNMENT ARE NOT CORRECT OR CANNOT
BE DETERMINED:
2. BALKED LANDING Procedures – EXECUTE.
3. Enter correct destination, runway, and required landing distance into the G5000 system:
a. From the GTC Home screen: PERF – Landing Data.
Procedure completed