GNS 430 Pilot’s Guide and Reference
4-4
SECTION 4
DIRECT-TO NAVIGATION
Shortcuts
Shortcuts are available when using the Direct-to Key,
allowing the pilot to bypass the use of the small and large
right knobs to enter the destination waypoint’s identifier.
A direct-to can be performed from any page displaying
a single waypoint identifier (such as the WPT pages for
airports and NAVAIDS, see Figure 4-9) by simply pressing
the Direct-to Key and the ENT Key. For pages that display
a list of waypoints (e.g., the Nearest Airport Page, see
Figure 4-10), the desired waypoint must be highlighted
with the cursor before pressing the Direct-to Key.
Figure 4-9 Single Waypoint Displayed
Figure 4-10 Nearest List
To select an on-screen waypoint as a direct-
to destination:
1) If a single airport, NAVAID, or user waypoint is
displayed on-screen: press the Direct-to Key,
then press the ENT Key twice.
2) If
a list of waypoints is displayed on-screen:
press the small right knob to activate the
cursor.
3) Turn the large right knob to highlight the
desired waypoint.
4) Press the Direct-to Key followed by the ENT
Key twice
.
To Next Page
Loading...
