CHAPTER 13: Adding and Replacing Components www.gateway.com
146
5 Press and hold the the drive release latch in toward the drive, then slide
the drive out of the drive bay.
6 Remove the hard drive.
7 Note any jumper settings on the old drive and set the jumper on the new
drive to be the same.
8 Slide the new drive into the drive bay, then slide the drive release latch
back.
9 If you are adding a drive, connect the drive cables to the new drive.
Jumper
8511629.book Page 146 Wednesday, July 19, 2006 9:38 AM
To Next Page
Loading...
