Replacing a CD, DVD, or Diskette Drive, or a Memory Card Reader
www.gateway.com
143
7 Locate the old battery on the system board and note its orientation. You
will need to install the new battery the same way.
8 Push the battery release tab. The battery pops out of the socket.
9 Make sure that the positive (+) side of the new battery is facing up, then
press the battery into the socket until it snaps into place.
10 Replace the side panel by following the instructions in “Replacing the side
panel” on page 140.
11 Reconnect all external cables and the power cord.
12 Turn on your computer.
13 Open the BIOS Setup utility.
14 In the BIOS Setup utility, restore any settings that you wrote down in
Step 3.
15 Save all your settings and exit the BIOS Setup utility.
Replacing a CD, DVD, or Diskette Drive, or a Memory Card
Reader
Tips & Tricks
You need a Phillips screwdriver to add or
replace a CD, DVD, or diskette drive, or a
memory card reader.
To replace a CD, DVD, or diskette drive, or a memory card reader:
1 Remove the side panel by following the instructions in “Removing the side
panel” on page 138.
2 Remove the front bezel by following the instructions in “Removing the
front bezel” on page 139.
8511629.book Page 143 Wednesday, July 19, 2006 9:38 AM
To Next Page
Loading...
Need help?
General
