Adding or replacing an expansion card
www.gateway.com
153
6 Connect the I/O panel cable to the new I/O panel.
7 Replace the front bezel by following the instructions in “Replacing the
front bezel” on page 140.
8 Replace the side panel by following the instructions in “Replacing the side
panel” on page 140.
Adding or replacing an expansion card
To add or replace an expansion card:
1 Remove the side panel by following the instructions in “Removing the side
panel” on page 138.
2 For more stability, place your computer on its side. To avoid scratching the
case, place it on a towel or other non-abrasive surface.
3 If you are adding a new expansion card, go to the next step. If you are
replacing an expansion card, go to Step 7.
4 Disconnect any cables that are attached to the card, noting their locations
and orientation. (You may need to reconnect the cables after you install
the new card.)
5 Open the card retention lever.
8511629.book Page 153 Wednesday, July 19, 2006 9:38 AM
To Next Page
Loading...
