Instructions for SL500DCL/SL800DCL
www.gatexpertstore.com
2. Press “PROG” button again for 3 sec. to enter into advanced menu. L0 will flicker
twice, then L1 will be steady on.
3. Press “+” button four times to select alarm lamp working mode option. Indicator light
L5 will be steady on.
4. Press “SET” button once to enter into alarm lamp working mode setting. Indicator
light L1 will show the current setting.
5. Press “+” or “-” button to set the alarm lamp working mode. Indicator light L1 on or off
will indicate the alarm lamp working mode. (L1 off: blinker; L1 on: steady on)
6. Press “SET” button once to save and system will automatically exit. The indicator
lights L1-L5 will be on in sequence, then all will flicker once and off.
B. Operation Graphic Illustration
Other Menu Setting
1. Press “PROG” button for 3 Sec. under the standby mode, indicator light L0 will flicker
once to enter into basic menu setting. Press “PROG” button again for 3 sec. indicator
light L0 will flicker twice to enter into the advanced menu setting. Then press “PROG”
L0 flicker once, L1
will be steady on
Press “PROG”
again for 3 sec.
L0 flicker twice, L1
will be steady on
Press “+” or “-” to set, LED
will show the setting value
L1-L5 will be on in
sequence then all
flicker once and off.
To Next Page
Loading...
