GATEXPERT SL500DCL - Buzzer Setting

Instructions for SL500DCL/SL800DCL
www.gatexpertstore.com
42
3. Press “PROG” button for 3 sec. for the third time to enter into other menu setting.  L0
will flicker three times, then L1 will be steady on.
4. Press “SET” button once to enter into emergency stop distance setting.  Indicator
light L1 to L5 will show the current setting value. (Default is L2)
5. Press “+” or “-” button to set the emergency stop distance.  Indicator lights L1-L5 will
indicate different distance, the more the indicator lights are on, the longer the distance
will be, the better the buffering will be before gate stopped.
6. Press “SET” button once to save and system will automatically exit.  The indicator
lights L1-L5 will be on in sequence, then all will flicker once and off.
B. Operation Graphic Illustration
Buzzer Setting(L2)
This setting is to enable or disable the buzzer, users can set to their required.
There are four types of buzzer this motor will make for different conditions:
1. Motor works normally under mains power: the buzzer sounds short but
long lasting.
Press “SET” once
Press “PROG” for
3 sec.
L0 flicker 3 times,
L1 will be steady
on
Press “PROG” for
3 sec.
L0 flicker once, L1
will be steady on
Press “PROG”
again for 3 sec.
L0 flicker twice, L1
will be steady on
Press “+” or “-” to set, LED
will show the setting value
Press “SET” once
Save and exit
PROG
PROG
PROG
SET
SET
L1-L5 will be on in
sequence then all
flicker once and off.