SP-53 Fan Monitor
Option: Function:
Select which reaction the frequency converter should take in case a fan fault is detected.
[0] Disabled
[1] * Warning
[2] Trip
SP-55 Output Filter
Option: Function:
Select if a Sine-Wave output filter connected. This parameter cannot be adjusted while motor is running.
[0] * No Filter
[1] Sine-Wave Filter
SP-56 Capacitance Output Filter
Range: Function:
2.0 uF* [0.1 - 6500.0 uF] Set the capacitance of the output filter. The value can be found on the filter label.
NB!
This is required for correct compensation in Flux mode (par. H-41 Motor Control Principle)
SP-57 Inductance Output Filter
Range: Function:
7.000 mH* [0.001 - 65.000 mH] Set the inductance of the output filter. The value can be found on the filter label.
NB!
This is required for correct compensation in Flux mode (par. H-41 Motor Control Principle)
SP-59 Actual Number of Inverter Units
Range: Function:
1.* [1 -] Set the actual number of power units.
SP-63 Option Supplied by External 24VDC
Option: Function:
[0] No Select No [0] to use the drive's 24 V DC supply.
[1] * Yes Select Yes [1] if an external 24 V DC supply will be used to power the option. I/O will be galvanically isolated
from the drive when operated from an external supply.
3.9.6 SP-7# Additional ADD/DEC Settings
Parameters to configure the jerk compensations for S-Ramps settings on Accel/Decel Ramps 1 through 4.
SP-71 Accel Time 1 S-ramp Ratio at Accel. Start
Range: Function:
50 %* [1 - 99. %] Enter the proportion of the total accel time (par. F-07 Accel Time 1) in which the acceleration torque
increases. The larger the percentage value, the greater the jerk compensation achieved, and thus the
lower the torque jerks occurring in the application.
AF-650 GP Programming Guide
111
3
To Next Page
Loading...
