2.1.7 Quick Menu Key Functions
Pressing [Quick Menus] The list indicates the different areas contained in the
Quick menu.
Select Quickstart to go through a limited amount of parameters to get the motor running almost optimally. The default setting for the other parameters considers
the desired control functions and the configuration of signal inputs/outputs (control terminals).
The selection of parameter is effected by means of the arrow keys. The parameters in the following table are accessible.
Parameter
Setting
par. K-01 Language
par. K-02 Motor Speed Unit
par. P-02 Motor Power [HP]
par. F-05 Motor Rated Voltage [V]
par. P-03 Motor Current [A]
par. F-04 Base Frequency [Hz]
par. P-06 Base Speed [rpm]
par. F-01 Frequency Setting 1
par. F-02 Operation Method
or
par. P-07 Motor Power [kW]
[kW]
par. F-07 Accel Time 1 [sec]
par. F-08 Decel Time 1 [sec]
par. F-10 Electronic Overload
par. F-17 Motor Speed High Limit [RPM]
or
par. F-15 Motor Speed High Limit [Hz]
par. F-18 Motor Speed Low Limit [RPM]
or
par. F-16 Motor Speed Low Limit [Hz]
par. H-08 Reverse Lock
par. P-04 Auto Tune [1] Enable complete Auto Tune
* If terminal 27 is set to “no function”, no connection to +24 V on terminal 27 is necessary.
Select Changes made to get information about:
•
the last 10 changes. Use the [
▲
] [
▼
] navigation keys to scroll between the last 10 changed parameters.
• the changes made since default setting.
Select Trendings to get information about the display line read-outs. The in-
formation is shown as graphs.
Only display parameters selected in par. K-20 Display Line 1.1 Small and par.
K-24 Display Line 3 Large can be viewed. It is possible to store up to 120
samples in the memory for later reference.
AF-650 GP Programming Guide
19
2
To Next Page
Loading...
