Reset Running Hours Counter ID-07 136
[Reset] Button On Keypad K-43 34
Resolution (positions/rev) EC-21 132
Resolution (ppr) EC-11 132
Resolver Interface RS-59 134
Resonance Dampening H-64 95
Resonance Dampening Time Constant H-65 95
Restore Factory Settings H-03 88
Reverse Lock H-08 89
Reversing Select O-54 120
Rfi Filter SP-50 110
Rotor Leakage Reactance (x2) P-34 86
Rotor Resistance (rr) P-31 86
Running Hours ID-01 135
S
Safety Precautions 8
Samples Before Trigger ID-14 137
Screened/armoured 11
Serial Communication 6
Service Code SP-29 109
Setpoint PB-00 127
Set-up Copy K-51 34
Set-up Copy, 0-51 34
Set-up Select O-55 121
Signal Type EC-10 132
Slave Error Count O-83 121
Slave Messages Rcvd O-82 121
Slip Compensation P-09 85
Slip Compensation Time Constant P-10 85
Software Version ID-43 139
Speed Pid Diff. Gain Limit PI-05 169
Speed Pid Differentiation Time PI-04 169
Speed Pid Feed Forward Factor PI-08 171
Speed Pid Feedback Gear Ratio PI-07 170
Speed Pid Feedback Source PI-00 169
Speed Pid Integral Time PI-03 169
Speed Pid Lowpass Filter Time PI-06 170
Speed Pid Proportional Gain PI-02 169
[Speed Rpm] DR-17 142
Ssi Data Format EC-26 132
Ssi Data Length EC-24 132
Start Current F-29 43
Start Delay 42
Start Event LC-01 149
Start Function 42
Start Function F-25 42
Start Mode H-09 89
Start Select O-53 120
[Start Speed Hz] 42
[Start Speed Hz] F-23 42
[Start Speed Rpm] F-22 42
Stator Leakage Reactance 84
Stator Leakage Reactance (x1) P-33 86
Stator Resistance (rs) P-30 86
Status 14
Status Messages 13
Status Word DR-03 141
Status Word 1 PB-68 129
Step Size F-90 48
Step-by-step 23
Stop Delay B-24 167
Stop Event LC-02 150
Store Always DN-33 126
Store Data Values DN-31 126
Sw Id Control Card ID-49 139
Sw Id Power Card ID-50 139
AF-650 GP Programming Guide
211
To Next Page
Loading...
