[40] Out of ref range
[41] Below reference, low
[42] Above ref, high
[45] Bus ctrl.
[46] Bus ctrl, 1 if timeout
[47] Bus ctrl, 0 if timeout
[55] Pulse output
[60] Comparator 0
[61] Comparator 1
[62] Comparator 2
[63] Comparator 3
[64] Comparator 4
[65] Comparator 5
[70] Logic rule 0
[71] Logic rule 1
[72] Logic rule 2
[73] Logic rule 3
[74] Logic rule 4
[75] Logic rule 5
[80] Logic Controller digital output A
[81] Logic Controller digital output B
[82] Logic Controller digital output C
[83] Logic Controller digital output D
[84] Logic Controller digital output E
[85] Logic Controller digital output F
[120] Local ref active
[121] Remote ref active
[122] No alarm
[123] Start command activ
[124] Running reverse
[125] Drive in hand mode
[126] Drive in auto mode
E-57 Term X30/7 Digi Out (OPCGPIO)
Option: Function:
[0] * No operation This parameter is active when option module OPCGPIO General Purpose I/O Option Module is mounted
in the frequency converter.
[1] Control ready
[2] Drive ready
[3] Drive rdy/rem ctrl
[4] Enable / no warning
[5] Drive running
[6] Running / no warning
[7] Run in range/no warn
[8] Run on ref/no warn
[9] Alarm
[10] Alarm or warning
AF-650 GP Programming Guide
74
3
To Next Page
Loading...
