What to do if GE Medical Equipment shows alarm 'Compressed air failure during run'?
If the GE Medical Equipment displays the alarm 'No air supply to the system' and pauses, it indicates insufficient air pressure, possibly from malfunctioning air supply equipment or a leaking air hose. First, rectify the air supply problem. Then, restart the run by clicking the PAUSE/CONTINUE button.
What to do if GE AKTA ready XL Medical Equipment shows alarm 'Valve error'?
If the 'Valve error' alarm appears on the GE Medical Equipment, a valve lock might be open. Check the valve locks, ensuring the valve is in the open position before closing any manual valve lock. If the 'Valve error' alarm is accompanied by 'No air supply to the system', it is caused by a compressed air failure. Ensure the compressed air supply is at least 6.5 bar g.
What to do if GE Medical Equipment has communication failure during a run?
If there is a communication failure during a run with the GE Medical Equipment, ensure the system is switched on and check the network cables and connectors. Also, reboot the PC by shutting down Windows, switching off the system power, waiting at least 5 seconds, and then restarting the system.
What to do if GE AKTA ready XL experiences a power failure during a run?
In case of a power failure during a run of the GE Medical Equipment, check the circuit breaker, both in the system and for the external supply, as applicable.
How to troubleshoot failed installation test on GE AKTA ready XL Medical Equipment?
To troubleshoot a failed installation test on the GE Medical Equipment: 1. Check that the flow kit is installed according to the Operating Instructions. 2. Check that the sensor cables are fitted properly. 3. Check that all pinch valves are closed. 4. Check that all TC clamps are fitted properly. 5. Check that the pump head is fitted properly. 6. Rerun the flow kit installation test. 7. If rerunning the test a second time does not solve the issue, replace the flow kit.
What to do if GE Medical Equipment has no or too low flow?
If the GE Medical Equipment experiences no or too low flow: * Stop the pump and make sure the tubing is not twisted (also check inside the pinch valves). * Also check that tubing leading to the system is of the correct size and not twisted.
What to do if no system is found when starting GE AKTA ready XL control software?
Reboot the PC: shut down Windows, switch off the system power switch, wait at least 5 seconds, and then restart the system. If this action does not solve the problem, no answer.
General| Brand | GE |
|---|---|
| Model | AKTA ready XL |
| Category | Medical Equipment |
| Language | English |
To Next Page
