6 Operation
A
bout this chapter
This chapter provides the information required to start, run and shut down ÄKTA
ready XL after a run.
For instructions on method/phase creation and results evaluation, refer to the con-
trol software user documentation.
Note: Make sure the installation steps described in the previous chapter have
b
een performed.
In this chapter
Section See page
6.1 Connect a column 131
6.2 Run a method 134
6.3 Controlled shutdown and removal of flow kit 139
Precautions
WARNING
B
efore attempting to perform any of the procedures described in
this chapter, you must read and understand all contents of the
corresponding section(s) in the links as listed below:
• G
eneral precautions, on page 13
• Personal protection, on page 15
• Operation, on page 18
6 Operation
130
ÄKTA ready XL Operating Instructions 29281616 AE
*** TeDIS Valid on Date Printed Printed on: 15-09-2023 11:27:35 ***
To Next Page
Loading...
