6-16 ApexPro™ Telemetry 2001989-203C
Troubleshooting
5. To display all the transceivers that are currently attached to an access point, select
the applicable link in the Xmits column.
107A
6. View the information displayed on the Transceiver List. This screen provides the
following information:
Column Description
Num The access point number in the Device Master configuration.
NOTE
A dash (-) is displayed if the access point is not present in the
Device Master table.
RF ID The access point RF module ID.
IP Address The IP address for the access point.
AP Act The active state of the access point. Values are:
Y = Yes
N = No
AP Sync Displays the sync state of the access point:
Y = Yes
N = No
NOTE
A dash (-) is displayed if the access point is not active.
AP Ver The access point firmware version.
RFA Ver The access point RF module A firmware version.
RFB Ver The access point RF module B firmware version.
Xmits The number of transceivers that are currently attached to the access
point.
To Next Page
Loading...
Need help?
General
