GE Druck ADTS 405 R Mk2 User Manual

viii | ADTS 405 R/F Mk2 Instruction Manual-English © 2017 General Electric Company – All Rights Reserved.
4.1.3 Pt Only Display 30
4.2 Changing the Display 30
4.2.1 Change to Single, Dual or Triple Display 31
4.2.2 Changing the Display for Pt Only 31
4.3 Changing the Units 31
4.3.1 Changing the Measurement Units 31
4.3.2 Changing the Unit Type 31
4.4 Aim 32
4.5 Leak Measure 32
4.5.1 UUT Leak Test 32
4.5.2 ADTS 405 Mk2 Leak Test 32
4.6 Aircraft System Protection 34
4.6.1 Auto Recovery Facilities 35
4.6.2 Limit Checking 35
4.7 Changing Parameters 36
4.7.1 Mach Test and Constant Mach 36
4.7.2 True Airspeed 36
4.8 Airspeed Switch Test 36
4.9 Engine Pressure Ratio (EPR) 37
4.9.1 Example EPR Test 37
4.10 Testing Aircraft Systems or UUT 38
4.10.1 Go To Ground and Shutdown 38
4.10.2 While Going to Ground 38
4.10.3 Resuming Testing after Going to Ground 38
4.11 Setup Options 39
4.11.1 Change Units in Full Setup Mode 39
4.11.2 Change Units in Minimum Setup Mode 40
4.12 Configuration Options 40
4.13 Communications Panel Options 40
4.13.1 Ethernet System 40
4.13.2 Changing the Default Access Password 42
4.13.3 Access ADTS Files 43
4.14 IEEE 488 Option 45
4.14.1 Enabling the IEEE 488 Option 45
4.14.2 IEEE 488 Connector 46
4.15 Enabling the Altimeter Encoder Option 47
5. Maintenance 49
5.1 Introduction 49
5.2 Materials 49
5.3 Maintenance Tasks 50
5.4 Routine Maintenance 51
5.4.1 Servicing Procedures 51
5.4.2 Replacing the Output Connector O-ring 51
5.4.3 Fuse Replacement 51

GE Druck ADTS 405 R Mk2 Specifications

General

Brand	GE
Model	Druck ADTS 405 R Mk2
Category	Test Equipment
Language	English