Chapter 3. Getting Started
26 | ADTS 405 R/F Mk2 Instruction Manual-English © 2017 General Electric Company – All Rights Reserved.
3.5.4 Go to Ground (Control to Local Ground Pressure)
Dual parameter display Single parameter display
Note: In Leak Measure, use F2
and F3 for QFE and QNH
information. F1 is only valid in
Control mode.
Note: This ground value will
not be zero and depends on
local atmospheric pressures
erhemvƉiphepxmxyhi
Note: Safe to disconnect
pipes and adaptors from the
aircraft or component under
test.
To Next Page
Loading...
