Chapter 7. Reference
98 | ADTS 405 R/F Mk2 Instruction Manual-English © 2017 General Electric Company – All Rights Reserved.
7.4.35 CONFIG, GROUND
CONFIG equivalent of SETUP function.
7.4.36 CONFIG, PORT
Refer to the Line Switching Unit User Manual.
7.4.37 CONFIG, REMOTE
This function disables the front panel keypad and allows the ADTS 405 Mk2 to be controlled
by a remote device such as a PC. The front panel display shows the “REMOTE” message. To
return to “LOCAL” control (keypad) press the REMOTE/LOCAL key. The remote device can
disable this key.
Some ATE systems may require the ADTS 405 Mk2 set in the remote mode before the remote
device starts communicating. If remote lock is disabled, set the ADTS 405 Mk2 while in local
control, by pressing the REMOTE/LOCAL key.
7.4.38 CONFIG, ETP, [AUTO RUN]
Causes a down-loaded test program to operate (Execute Test Program) on power-up. See the
Test Program Manager User Manual for further details.
7.4.39 CONFIG, ETP, [ERASE PROGRAMS]
Removes a down-loaded test program from non-volatile memory. See the Test Program
Manager User Manual for further details.
7.4.40 CONFIG, ETP, [RESULT]
1. Configures the PRINT/SAVE mode as in setup mode.
2. Selects and deletes a result file stored in the ADTS 405 Mk2.
7.4.41 CONFIG, NUDGE
CONFIG equivalent of SETUP function.
7.4.42 CONFIG, 000
1. This function enables, changes or disables the CONFIG PIN code protecting access to
CONFIG menu.
2. When enabled, the PIN must be entered before it can be changed. The prompt asks
for “Enter existing PIN”, then a new PIN can be entered. This must comprise four
numeric digits.
3. Once entered, the prompt asks for the new PIN again to protect against data entry
errors. To disable the PIN, so that CONFIG can be entered without a PIN, enter 0000.
INFORMATION Changing between sets of limits can cause damage to
sensitive instruments. Entering CONFIG disables lock out. There are two
sets of limits: “REMOTE” and “LOCAL”.
To Next Page
Loading...
