© 2017 General Electric Company – All Rights Reserved. ADTS 405 R/F Mk2 Instruction Manual-English | v
Returned Goods Procedure
If the unit requires calibration or is unserviceable, return it to the nearest GE Service Centre
listed at: www.gemeasurement.com
Contact the Service Department to obtain a Return Authorization (Worldwide excluding
USA).
In the USA, obtain a Return Material Authorization [RMA].
Provide the following information on either a RGA or RMA:
• Product (i.e. ADTS 405F Mk2 or ADTS 405R Mk2).
• Serial number.
• Details of defect/work to be undertaken.
• Include any error code(s) and hex value(s) if available. See Section 6.2, “Error
Messages,” on page 57 for more details.
• Operating conditions.
Install To perform operations necessary to properly fit an equipment unit into the
next larger assembly or system.
Maintain To hold or keep in any particular state or condition especially in a state of
efficiency or validity.
Operate Ensure that an item or system functions correctly as far as possible without
the use of test equipment or reference to measurement.
Readjust To adjust again; to move back to a specified condition; to bring back to an in-
tolerance condition.
Reconnect To rejoin or refasten that which has been separated.
Refit Fit an item which has previously been removed.
Remove To perform operations necessary to take an equipment unit out of the next
larger assembly or system. To take off or eliminate. To take or move away.
Repair To restore damaged, worn out or malfunctioning equipment to a serviceable,
usable or operable condition.
Replace Remove an item and fit a new or a serviced item.
Reset To put back into a desired position, adjustment or condition.
Service To perform such operations as cleaning, lubricating and replenishing to
prepare for use.
Test Ascertain by using the appropriate test equipment that a component or
system functions correctly.
Item Description
To Next Page
Loading...
Need help?
General
