GE Giraffe - 4.3 Alarm Messages

Girae Warmer 3-18
Using the In-Bed Scale (optional)
The Giraffe Warmer can be equipped with its own in-bed scale that is operated from the control panel
screen.
Scale installation
Illustration
Step
Description
1
1. Remove the clear Plexiglas plate (2) and
mattress (1) from the bed.
2. Fit the scale weighing platform (3) into the
recesses in the bed (4).
3. Route the scale cable (5) though the gap at
the corner of the bedside panels and plug
the connector into the jack.
4. Place the Plexiglas plate and mattress on
the weighing platform. Ensure that they
are properly seated on the platform.
NOTE: The scale may be connected
or disconnected at any time.
Weighing procedure
The baby should be in approximately the center of the bed. Stued animals and other objects should
not lean against bedsides. All leads, I.V. tubes and ventilator tubes should be secured. Blankets may
be tucked under the mattress, but must not be tucked under the weighing platform.
Screen
Step
Description
1
Press the “Menu’ key, then select the “Scale”
key to bring up the scale menu. If the scale is
not connected, no icon will appear.