GE Healthcare Brivo XR118 - Page 113

GE HEALTHCARE
DIRECTION 5461425-8EN, REVISION 6 BRIVO XR118 SERVICE MANUAL
Chapter 5 - - Installation & Configuration Page 113
9.12.4 Trigger
The following bar codes will allow you to use the reader in Manual Trigger mode (need to press the
trigger to read), Automatic Trigger mode (the beam is always on), or Presentation mode (the reader
is activated when it “sees” a bar code).
9.12.5 Reread Delay
This sets the time period before the scanner can read the same bar code a second time. Setting a
reread delay protects against accidental rereads of the same bar code.
9.12.6 Suffix
If you want a carriage return after the bar code, scan the Add CR Suffix bar code. To add a tab after
the bar code, scan the Add Tab Suffix bar code. Otherwise, scan the Remove Suffix bar code to
remove the suffixes.
9.12.7 Add Code ID Prefix to all Symbologies
Scan the following bar code if you wish to add a Code ID prefix to all symbologies at once.