GE Healthcare Brivo XR118 - 8.3 System Software Installation

GE HEALTHCARE
DIRECTION 5461425-8EN, REVISION 6 BRIVO XR118 SERVICE MANUAL
Page 66 Section 8.0 - Software Installation
8.3 System Software Installation
8.3.1 Personnel Requirements
8.3.2 Overview
• The following times are typical for a complete system LFC:
1.) Five Minutes to backup system files to CD/DVD.
2.) Approximately ninety minutes to save images and protocols.
3.) Fifteen minutes to install the OS and Applications software.
4.) Five Minutes to restore system files from CD/DVD.
5.) Five minutes to cleanup and return system to operational readiness.
• 5461425-8EN
Only use this System Installation procedure to re-install and/or upgrade your system software
completely. The following procedure installs both the operating system, and application
software.
• Pay particular attention, if instructed, to system resets. It's important that power be cycled
according to a specified procedure. Cycling power at the wrong time or by the wrong method
can result in a PC's operating file system (Linux) becoming corrupted. If the OS on the PC gets
corrupted, you may have to reload it again or start over.
• The following SW procedure assumes that you are beginning with the System powered “ON”
and application software running (i.e. System Operationally Ready).
Note: Configure the Time Zone after software re-installation or upgrade.
Required
Persons
Preliminary
Reqs
Procedure
Finalizati
on
1 5 mins
15 (Time estimate does not include saving
and restoring patient images and/or
protocols files)
0 min