EasyManua.ls Logo

GE Healthcare Brivo XR118 - 9.4 Hospital Network Configuration

GE Healthcare Brivo XR118
318 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GE HEALTHCARE
DIRECTION 5461425-8EN, REVISION 6 BRIVO XR118 SERVICE MANUAL
Chapter 5 - - Installation & Configuration Page 77
9.4 Hospital Network Configuration
Go to SUIF -> Configuration -> Networking. After selected and committed the change, reset system.
Table 12-4 Wired Fixed IP Settings
Parameter Definition
DHCP Configuration
If enabled (Yes), the hospital wired IP interface will acquire IP settings
from DHCP server on the hospital network.
If static IP is assigned by hospital, this item should be set as
disabled (No).
IP Address Fixed Only 16 characters maximum, mandatory for Static IP configuration.
Subnet Mask Fixed
Only
16 characters maximum, mandatory for Static IP configuration.
Default Gateway
Fixed Only
16 characters maximum. Note: If the customer site does not have a
default gateway, use the default value loaded upon installation. The field
cannot be empty, mandatory for Static IP configuration.
Static DNS Server 1 (Optional)16 characters maximum.
Static DNS Server 2 (Optional)16 characters maximum.

Table of Contents

Related product manuals