Be sure to inform the customer that the cost of any alteration or modification not specified in the sales
contract are liable to the customer.
The following GE-supplied equipment must be installed by the Hospital's Contractors, per room drawings:
• PDB (Electrical Power Distribution Box or Main Disconnect Panel)
• Frontal Gantry & Table baseplates with holes drilled (Per supplied template)
• Lateral Gantry Suspension stationary rails (centered on Frontal Gantry/table floor template)
• (For Suspension with rails) Monitor suspension stationary rails
• (For LDM Suspension with fixed point Dual Arm) Substructure for Dual Arm suspension (S18391MX)
NOTE
Means necessary to anchor of the Substructure for Dual Arm suspension (anchors, bolts,
screws, etc.) are not delivered with the kit and should be provided and designed under
customer responsibility.
• Lateral Gantry cable drape rail(s)
• Frontal Gantry baseplate grout
• Frontal Gantry baseplate
• Table baseplate (if applicable)
NOTE
For systems with Fluoro UPS CE cabinet only: It is the customer responsibility to install a
fire extinguisher (non-water type, ex. CO2) in the technical room, close to the Fluoro UPS
CE cabinet location.
1.2.2 Equipment Classifications
The following equipment classifications are applicable to the product:
Classification category Equipment classification
Protection against electric shock Class I.
WARNING
TO AVOID THE RISK OF ELECTRIC SHOCK, THIS EQUIP-
MENT MUST ONLY BE CONNECTED TO A SUPPLY MAINS
WITH PROTECTIVE EARTH.
Degree of protection against elec-
tric shock
Type B applied parts
Applied parts complying with the specified requirements of the IEC 60601-1
standard to provide protection against electric shock, particularly regarding
allowable patient leakage current and patient auxiliary current, include Mat-
tress.
General Requirements
5750182-1EN 3
Innova
TM
IGS 6
3
To Next Page
Loading...