The ECG Device/Room configurations need to be checked as this can impact ON the way parts and
cables can be installed.
Basically, there will be two different Installation Configurations depending on the type of ECG device to
connect to the Innova system:
Installation Configuration #1:
For ECG devices installed in Control Room (such as GE ECG like MacLab, CardioLab or ComboLab)
Both the Physio & Hubican modules are installed in the Control Room as shown below:
Figure 2-39
Installation Configuration #2:
For ECG devices installed in Exam Room (ECG device from the competitor)
Physio and/or Hubican modules will be installed in Exam Room as shown below:
Equipment Requirements
5750182-1EN 3
Innova
TM
IGS 6
79
To Next Page
Loading...