LOGIQ C9 Series – Basic Service Manual Index-1
5482298-100 English Rev. 5
Index
A
abbrevations, 9-3
acclimate time, 2-3
authorized representative in EU, 1-27
average setup time, 3-3
B
before installation (site preparations), 2-1
Boot Up, 3-21
C
cable inspection
mains cable inspection, 10-14
care and maintenance, 10-1
warnings, 10-3
CE compliance, 1-23
change history, i-1
chapter 1
introduction, 1-1
chassis leakage current test, 10-25
cold or hot
if the unit is very cold or hot, 2-3
compatibility
hardware/software, 9-4
completing the setup, 3-19
compliance, 1-23
configuration, 3-22
connect
ethernet, 3-21
probe, 3-21
USB flash card, 3-21
connections
on the rear panel, 3-21
console environmental requirements, 2-3
console requirements, 2-3
contact information, 1-25
contents in this manual, 1-3
conventions used in book, 1-6
cooling, 2-5
copyrights, i-15
customer assistance, 1-25
phone numbers, 1-26
customer order
verification, 3-18
customer provided prerequisite, 8-13
D
damage
in transportation, 3-11
damage in transport, i-12
dangerous procedure warnings, 1-20
data network setup requirements, 2-18
desirable features, 2-15
DICOM network function, 2-19
DICOM setup requirements, 2-20
display PDF files
from manual CD-ROM
print PDF files
from manual CD-ROM, 4-18
E
electrical requirements, 2-6
EMI limitations
EMI limitations, 2-9
general requirements, 2-6
site circuit breaker
site circuit breaker, 2-7
site power outlets
site power outlets, 2-7
specific requirements for the unit, 2-6
unit power plug
unit power plug, 2-7
electrical safety, 1-18
electrical safety tests, 10-19
electrical specification, 3-20
electromagnetic interference
abatement, 2-10
prevention, 2-10
electrostatic discharge prevention, 1-24
EMC, 1-23
compliance, 1-23
what is EMC?, 1-23
EMI, 1-23
abatement, 2-10
prevention, 2-10
protection, 3-18
environmental dangers, 2-22
environmental specifications for the unit, 2-4
errors, i-13
ESD, 1-23
ESD prevention, 1-24
ethernet
To Next Page
Loading...
Need help?
General
