GE LOGIQ S8 User Manual

GE HEALTHCARE
DIRECTION 5394227, 12 LOGIQ S8/LOGIQ E8 SERVICE MANUAL
7 - 4 Section 7-2 - Service Platform
7-2-5 Customer Granting Full Remote Access Permission to GE Service Technician
7-2-5-1 If GE Service Technician requests Remote Access Permission
If a GE Service technician requests remote access to your LOGIQ S8 scanner, following “InSite
Notification” appears on the systems screen.
1.) Enable “Disruptive Mode” feature by confirming Yes.
NOTE: If the customer does not wish to have diagnostics running at the time of the request, they select
No. A message is sent back to the OLC or FE that “Disruptive Mode” is not enabled.
NOTE: The user must have Remote service access rights to authorize disruptive mode.
Figure 7-4 Insite Notification
select [Yes] to enable
“Disruptive Mode” feature

GE LOGIQ S8 Specifications

General

Type	Ultrasound System
Display Type	LCD
3D/4D Imaging	Yes
Connectivity	DICOM, USB, Ethernet
Display Size	19 inches
Transducers	Linear, Convex, Phased Array
Doppler Modes	Color Doppler, Power Doppler, Spectral Doppler
Operating Modes	B-Mode, M-Mode
Applications	Abdominal, Cardiac, Obstetrics, Gynecology, Vascular, Musculoskeletal
Portability	Cart-based
Transducer Ports	4