GE MM300 - Page 25

CHAPTER 2: INSTALLATION MECHANICAL INSTALLATION
MM300 MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL 2–5
Screw mounts for high vibration environments are illustrated below.
Figure 2-6: Base Unit screw mounting
Figure 2-7: Expansion Unit screw mounting
MEETS VIBRATION REQUIREMENT OF
IEC 60255 SEC 21.1, 21.2, & 21.3
2.250”
(57,15 mm)
#6 -32 THREADED HOLE
QTY: 2
4.100”
(104,14 mm)
853727A2.CDR
#6-32X1/2FT FLATHEAD PHIL ZINC
QTY:2;TIGHTENING TORQUE:10lb.in.C
#6-32X1/2 FT FLAT HEAD PHIL ZINC
QTY: 2; TIGHTENING TORQUE: 10 lb. in.
0.356”
[9.03 mm]
0.672”
[17.06 mm]
1.500”
[38.10 mm]
EXPANSION UNIT
OUTLINE
2.285”
[58.04 mm]
#6-32 THREADED HOLE
QTY: 2
853755A2.cdr