GE SIGNA Voyager - 2.3 Magnet Monitor (MON) Requirements and Specifications

2.3 Magnet Monitor (MON) Requirements and Specifications
2.3.1 Requirements
1. Customer must supply 100Base-T network connection with RJ45 connector to the Magnet
Monitor (MON)
2.
The network connection must not be routed through the Ethernet switch in the Global
Operator Cabinet (GOC)
3.
The Magnet Monitor requires a 110/220 VAC, 50/60 Hz, 2.0 A facility supplied outlet. Power
at the outlet must be continuously available
2.3.2 Specifications
1. Mounting location: On the wall near the Cryocooler Compressors
2.
Weight: 10 lbs (4.5 kg)
3. Maximum gauss limit: 200 gauss (20 mT)
4.
Power cord length: 72 in. (1829 mm)
SIGNA Voyager Pre-Installation
Direction 5680008–1EN, Revision 2
Chapter 4 Equipment Room 105