EasyManua.ls Logo

GE SIGNA Voyager - Long; Short Cable Selection Guidance

GE SIGNA Voyager
178 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1.3 Long / Short cable selection guidance
This section describes the Long / Short cable selection guidance referring to Illustration 6-1.
NOTE:
This guidance is based on the assumption that the distance between cable tray and
floor is 8.53 feet (2.6m).
Magnet Room Cable
If the Magnet – ISC Distance is less than 17.7 feet (5.4 m) , select short cable.
If the Magnet – ISC Distance is in between 17.7 feet (5.4 m) and 30.8 feet (9.4 m) , select
long cable.
Equipment Room Cable
If the ICC – ISC Distance is less than 1.3 feet (0.4 m) , select short cable.
If the ICC – ISC Distance is in between 1.3 feet (0.4 m) and 21 feet (6.4m) , select long
cable.
Illustration 6-1: Distance for cable selection
SIGNA Voyager Pre-Installation
Direction 5680008–1EN, Revision 2
Chapter 6 System Interconnections 131

Table of Contents

Related product manuals