GE Xcellerex XDM Series User Manual

User maintenance schedule
The following table describes maintenance activities that must be scheduled by customer
personnel. All maintenance that is not described in this manual must be performed by
a GE service engineer.
ReferencePerformed byActivityFrequency
Section 8.5 Cleaning, on
page 257
OperatorClean the systemWeekly
See the manufacturer's
manual.
Properly trained person-
nel
Change the TCU filterAnnually
Contact your GE represen-
tative.
GE service engineerChange the I/O Cabinet
vent filter
Verify agitator alignment
If anything abnormal is
found, contact your GE
representative for ser-
vice.
Properly trained person-
nel
Inspect cables and con-
nectors
Annually and after
system relocation
Inspect hinges and han-
dles
Inspect jacking bolts, on
page 259
Properly trained person-
nel
Inspect jacking bolts
If anything abnormal is
found, contact your GE
representative for ser-
vice.
Properly trained person-
nel
Inspect pressure relief
assembly
Inspect pump heads
Inspect the I/O Cabinet
Inspect vent and drain
valves
Verify weight monitoring
accuracy, on page 261
Properly trained person-
nel
Verify weight monitoring
functionality
Contact your GE represen-
tative.
GE service engineerVerify agitator speed ac-
curacy
1
As needed
1
If the instrument is used less than 12 times a year, the verification can be made annually.
Xcellerex XDM 50-1000, XDUO 100-1000 mixers Operating Instructions 29251615 AD 251
8 Maintenance
8.2 Maintenance schedules

GE Xcellerex XDM Series Specifications

General

Brand	GE
Model	Xcellerex XDM Series
Category	Mixer
Language	English