Geeetech Prusa I3 pro W Building Instruction

52
www.geeetech.com
Shenzhen GETECH CO.,LTD
Step 1.Mount the pulley on the motor shaft and fix it from the flat side.
Note the direction of the pulley: the gear is at the bottom.
Step 2.Mount the stepper motor to the motor end with 3 M3x6mm screws and M3
washers.

Geeetech Prusa I3 pro W Specifications

General

Brand	Geeetech
Model	Prusa I3 pro W
Category	3D Printers
Language	English