Geeetech Prusa I3 pro W Building Instruction

11
www.geeetech.com
Shenzhen GETECH CO.,LTD
* Tips: Try to keep the thread rods parallel and the four wood pieces parallel. The
Y-axis must be a rectangle, that is the rods on both side should be parallel, so is the
front and back plate. Otherwise it will cause obstruction for the belt later. You can use
a Digital Caliper to measure.
4 Mount the Y Motor
Picture Part ID Required quantity Required parts
NO. W13 1 Y motor fix plate
NO.58 1 Stepper motor
NO.39 1 Pulleys
NO.22 3 M3 x 10mm screw
NO.24 2 M3 x 16 mm screw

Geeetech Prusa I3 pro W Specifications

General

Brand	Geeetech
Model	Prusa I3 pro W
Category	3D Printers
Language	English