gefran AFE200 Series

132 AFE200 • Instruction Manual
indicates the end of pre-loading. It is used to close the main contactor and open the
pre-load resistor contactor.
Menu PAR Description UM Type FB BIT Def Min Max Acc
- 1210 Digital input 1X mon BIT 16BIT 0 0 1 ER
- 1212 Digital input 2X mon BIT 16BIT 0 0 1 ER
- 1214 Digital input 3X mon BIT 16BIT 0 0 1 ER
- 1216 Digital input 4X mon BIT 16BIT 0 0 1 ER
- 1218 Digital input 5X mon BIT 16BIT 0 0 1 ER
- 1220 Digital input 6X mon BIT 16BIT 0 0 1 ER
- 1222 Digital input 7X mon BIT 16BIT 0 0 1 ER
- 1224 Digital input 8X mon BIT 16BIT 0 0 1 ER
These signals represent the state of the corresponding digital input on the expansion card.
Menu PAR Description UM Type FB BIT Def Min Max Acc
- 1530 Analog inp1 BIT 16BIT 0 0 1 ER
This signal is active when the value of the analog input is below the threshold set in
parameter 1520 Analog inp 1 thr
Menu PAR Description UM Type FB BIT Def Min Max Acc
- 1580 Analog inp2 BIT 16BIT 0 0 1 ER
This signal is active when the value of the analog input is below the threshold set in
parameter 1570 Analog inp 2 thr.
Menu PAR Description UM Type FB BIT Def Min Max Acc
- 2388 Active curr noflt A FLOAT 16BIT 0.0 0.0 0.0 ER
The active current reference is displayed without lter.
Menu PAR Description UM Type FB BIT Def Min Max Acc
- 3260 Bres overload accum perc UINT16 16BIT 0 0 100 ER
The braking resistor overload limit is displayed (100% = alarm threshold). This param-
eter is not available for the standard version of the AFE200..
Menu PAR Description UM Type FB BIT Def Min Max Acc
- 4708 Alm dig out mon 1 BIT 16BIT 0 0 1 ER
This signal is activated when the alarm congured in parameter 4700 alarm dig sel 1
is active.
Menu PAR Description UM Type FB BIT Def Min Max Acc
- 4710 Alm dig out mon 2 BIT 16BIT 0 0 1 ER
This signal is activated when the alarm congured in parameter 4702 alarm dig sel 2
is active.
Menu PAR Description UM Type FB BIT Def Min Max Acc
- 4712 Alm dig out mon 3 BIT 16BIT 0 0 1 ER